Dimensions: 29x29x1,6cm; Through height 3mm; Through width 10mm, gates 5mm
Material: acrylic glass, foam
Color: White, transparent
Includes:
4x Acrylic plates 29x29cm (incl. sponge)
14x screws transparent
14x nuts transparent
10x wall section with gate
10x wall section without gate
2x connection sockets 6mm transparent
2x Formicarium cap stainless steel for 6mm socket
1x mesh insert 27mm made of stainless steel
Connection: 2x connection sockets 6mm for hose 10 / 6mm
Description: Flatformicarium made of several layer plates and a special sponge for the wetness of the nest. Via the integrated connection sockets, the Formicarium can be extended via hoses or connected with an antsarena. In the left part of the nest there is a free area which is suitable for the placement of feeding bowls. The mesh insert provides for sufficient ventilation. The interchangeable wall sections enalbles to open (with gate) or close (without gate) the different districts. If the nest looks too sterile, you can also for your ants put ground (sand/loam) into the chambers.
Application: for ants of size S
Note: Slots of 0.5mm can occur.
Note about the connection sockets
The following must be observed when attaching or removing flexible tubes:
If the flexible tube is very difficult to fit on the connector socket, the socket should be lightly rubbed with a drop of our ant escape protection oil or powder. The flexible tube should then be pushed onto the connector socket by turning resp. screwing without loading the socket with up and down movements. The same applies when removing the flexible tube. Please do not just pull it out!